Development of Lightweight Thermoplastic Acrylic PMMA Composites and characterization of their Mechanical Properties

The effects of benzoyl peroxide (BPO) and dimethylaniline (DMA) composition on the induction time and the tensile strength of thermoplastic acrylic (PMMA) resins has been investigated in this study. Eighteen resin formulations were prepared with different the BPO/DMA ratio (2.0–9.5) and DMA content (0.28–0.65 mol%), and it was observed that tensile strengths reached up to 66 MPa, and induction times (IT) ranged from 100 to 207 minutes. Higher BPO/DMA ratios improved tensile strength but shortened IT, while greater DMA content accelerated curing. Polynomial regression models were successfully established, i.e. a third-order equation for the strength and a second-order equation for the IT, based on the BPO/DMA ratio and DMA content to identify the optimal formulation to balance the strength and the IT time. Two selected formulations, P-4-0.5 and P-3-0.3, were applied in vacuum-assisted resin infusion of glass-fiber composites. The best-performing unidirectional (UD) laminate achieved a tensile strength of 1244 MPa. ±45° biaxial (BX45) laminates exhibited a tensile strength of 124 MPa and a failure strain of 9.02%, which, while lower than that of epoxy, indicate competitive performance. These results demonstrate that the resin was well infused, resulting in 64% higher fiber volume fraction than typical infused glass/epoxy composites, and compositionally optimized PMMA resins can deliver epoxy-comparable strength and enhance damage tolerance in structural composite applications.